Refer to the exhibit. How should the FastEthernet0/1 ports on the 2950 model switches that are
shown in the exhibit be configured to allow connectivity between all devices?
A.
The ports only need to be connected by a crossover cable.
B.
SwitchX(config)# interface fastethernet 0/1
SwitchX(config-if)# switchport mode trunk
C.
SwitchX(config)# interface fastethernet 0/1 SwitchX(config-it)#switchport mode access
SwitchX(config-it)#switchport access vlan 1
D.
SwitchX(config)#interface fastethernet 0/1 SwitchX(config-if)#switchport mode trunk
SwitchX(config-it)#switchport trunk vlan 1 SwitchX(config-if)#switchport trunk vlan 10
SwitchX(config-it)#switchport trunk vlan 20