S0/0 on R1 is configured as a multipoint interface to communicate with R2 and R3 in the hub-andspoke Frame Relay topology shown in the exhibit. Originally, static routes were configured
between these routers to successfully route traffic between the attached networks. What will need
to be done in order to use RIP v2 in place of the static routes?
A.
Configure the no ip subnet-zero command on R1, R2, and R3.
B.
Dynamic routing protocols such as RIP v2 cannot be used across Frame Relay networks.
C.
Configure the s0/0 interface on R1 as two subinterfaces and configure point-to-point links to R2
and R3.
D.
Change the 172.16.2.0/25 and 172.16.2.128/25 subnetworks so that at least two bits are
borrowed from the last octet.
E.
Change the network address configurations to eliminate the discontiguous 172.16.2.0/25 and
172.16.2.128/25 subnetworks.