what password should be configured on the DeepSouth router in the branch office to allow a connection to be established with the MidEast router?

Please study the exhibit shown above carefully, and answer the following question.
If required, what password should be configured on the DeepSouth router in the branch office to
allow a connection to be established with the MidEast router?

Please study the exhibit shown above carefully, and answer the following question.
If required, what password should be configured on the DeepSouth router in the branch office to
allow a connection to be established with the MidEast router?

A.
No password is required.

B.
Enable

C.
Secret

D.
Telnet

E.
Console

Explanation:
In the diagram, DeepSouth is connected to Dubai’s S1/2 interface and is configured as follows:
Interface Serial1/2
IP address 192.168.0.5 255.255.255.252
Encapsulalation PPP ; Encapsulation for this interface is PPP
Check out the following Cisco Link:
http://www.cisco.com/en/US/tech/tk713/tk507/technologies_configuration_example09186a008009
4333.shtml#configuringausernamedifferentfromtheroutersname
Here is a snipit of an example:
Network Diagram
If Router 1 initiates a call to Router 2, Router 2 would challenge Router 1, but Router 1 would not
challenge Router 2. This occurs because the ppp authentication chap callin command is
configured on Router 1. This is an example of a unidirectional authentication.
In this setup, the ppp chap hostname alias-r1 command is configured on Router 1. Router 1
uses “alias-r1” as its hostname for CHAP authentication instead of “r1.” The Router 2 dialer map
name should match Router 1’s ppp chap hostname; otherwise, two B channels are established,
one for each direction.



Leave a Reply 0

Your email address will not be published. Required fields are marked *