Refer to the exhibit. The network administrator has created a new VLAN on Switch1 and added
host C and host D. The administrator has properly configured switch interfaces FastEthernet0/13
through FastEthernet0/24 to be members of the new VLAN. However, after the network
administrator completed the configuration, host A could communicate with host B, but host A could
not communicate with host C or host D. Which commands are required to resolve this problem?
A.
Switch1# vlan database
Switch1(vlan)# vtp v2-mode
Switch1(vlan)# vtp domain cisco
Switch1(vlan)# vtp server
B.
Router(config)# router rip
Router(config-router)# network 192.168.1.0
Router(config-router)# network 192.168.2.0
Router(config-router)# network 192.168.3.0
C.
Switch1(config)# interface fastethernet 0/1
Switch1(config-if)# switchport mode trunk
Switch1(config-if)# switchport trunk encapsulation isl
D.
Router(config)# interface fastethernet 0/1.3
Router(config-if)# encapsulation dot1q 3
Router(config-if)# ip address 192.168.3.1 255.255.255.0
Explanation:
Here is the example of configuring the router for inter-vlan communication
RouterA(config)#int f0/0.1
RouterA(config-subif)#encapsulation ?
dot1Q IEEE 802.1Q Virtual LAN
RouterA(config-subif)#encapsulation dot1Q or isl VLAN ID
RouterA(config-subif)# ip address x.x.x.x y.y.y.y