Which command will show the MAC addresses of stations connected to switch ports?
A.
show mac-address
B.
show arp
C.
show table
D.
show switchport
Which command will show the MAC addresses of stations connected to switch ports?
Which command will show the MAC addresses of stations connected to switch ports?
Now its clarified…am confused about th answer…thanks lot for
Answer: B
There is no “show mac-address” command. But notice the “show mac-address-table” and “show mac address-table” do exist.
If option A is “show mac-address-table” then both A & B are correct!
Yeah it is : B – “Show arp”
A lot of people confuse this question 🙂
The right answer is “show arp”
There is no such command as “show mac-address”, the right command is “show mac-address-table”
“show arp” would only be correct if you were on a multilayer switch hosting the gateway for the local subnet(s). I think the question is typo’d.
Show mac-address is the choise without using tab in writng command
SwitchC#show mac address
Mac Address Table
——————————————-
Vlan Mac Address Type Ports
—- ———– ——– —–
1 0001.c9a3.bc01 DYNAMIC Fa0/2
only write
Switch#show mac-address
you can see that it is valid, soo the option A is the correct
this command works only write show mac-address, you can try in packet tracert !! is not neccesary add xx-xx-table
Mac Address Table
——————————————-
Vlan Mac Address Type Ports
—- ———– ——– —–