Which of the following are true regarding the debug output shown in the graphic?(choose two)
A.
This router was configured with the commands:
RtrA(config)#router rip
RtrA(config-router)#version 2
RtrA(config-router)#network 172.16.0.0
RtrA(config-router)#network 10.0.0.0
B.
This router was configured with the commands:
RtrA(config)#router rip
RtrA(config-router)#network 172.16.0.0
RtrA(config-router)#network 10.0.0.0
C.
Network 10.0.0.0 will be displayed in the routing table.
D.
Network 192.168.168.0 will be displayed in the routing table.
E.
This router was configured with the commands:
RtrA(config)#router rip
RtrA(config-router)#network 192.168.1.0
RtrA(config-router)#network 10.0.0.0
RtrA(config-router)#network 192.168.168.0
F.
split-horizon was disabled on this router.
Explanation:
Routing Information Protocol (rip) is a distance vector protocol that uses hop as a metric. Rip routing metric: rip uses single routing metric (hops) to measure the distance from source network to destination network. From source to destination, every hop is given a value, which is usually 1. When routers receive route update information of new or changed destination network, the metric value will be added 1 and then stored into a routing table, the ip address of the sender will be used as the next hop address.