Which two of these changes are necessary for SwitchA to meet the requirements?

Refer to the exhibit:

A junior network administrator was given the task of configuring port security on SwitchA to allow only PC_A to access the switched network through port fa0/1. If any other device is detected, the port is to drop frames from this device. The administrator configured the interface and tested it with successful pings from PC_A to RouterA, and then observes the output from these two show commands. Which two of these changes are necessary for SwitchA to meet the requirements? (Choose two.)

Refer to the exhibit:

A junior network administrator was given the task of configuring port security on SwitchA to allow only PC_A to access the switched network through port fa0/1. If any other device is detected, the port is to drop frames from this device. The administrator configured the interface and tested it with successful pings from PC_A to RouterA, and then observes the output from these two show commands. Which two of these changes are necessary for SwitchA to meet the requirements? (Choose two.)

A.
Port security needs to be globally enabled.

B.
Port security needs to be enabled on the interface.

C.
Port security needs to be configured to shut down the interface in the event of a violation.

D.
Port security needs to be configured to allow only one learned MAC address.

E.
Port security interface counters need to be cleared before using the show command.

F.
The port security configuration needs to be saved to NVRAM before it can become active.



Leave a Reply 0

Your email address will not be published. Required fields are marked *