Refer to the exhibit:
Assuming that the entire network topology is shown, what is the operational status of the interfaces of R2 as indicated by the command output shown?
A.
One interface has a problem.
B.
Two interfaces have problems.
C.
The interfaces are functioning correctly.
D.
The operational status of the interfaces cannot be determined from the output shown.
This ans is not correct. the status of the interfaces should not even show as up because the addressing scheme overlaps. the se0/1 address belongs to the address range of fa0/0 which is a /26. subnet zero is in use. meaning the address for fa0/0 range is 172.16.109.1——62. they should have assign se0/1 from another subnet block.
Yes the diagram is off
but the output indicates that the interfaces are a ok. You can not place overlapping IP subnets on 2 interfaces in same router.
show run
interface FastEthernet0/0
ip address 10.1.50.6 255.255.255.252
ABERDEEN(config)#int serial 1/0
ABERDEEN(config-if)#ip address 10.1.50.1 255.255.255.0
% 10.1.50.0 overlaps with FastEthernet0/0
show run
interface Serial1/0
no ip address
So regardless what the diagram says, the output says there is no problem with the interfaces. And since the protocol is up it must be configure with a valid IP.
Now, none of them the correct answer
They are not over lapping. If the subnet is correctly assigned (which is not shown) you
can use those IP address on fe0/0 and s0/1