Lab- CLI
Central Florida Widgets recently installed a new router in their office. Complete the network installation by performing the initial router configurations and configuring R1PV2 routing using the router command line interface (CLI) on the RC.
Configure the router per the following requirements:
Name of the router is R2
Enable. secret password is cisco
The password to access user EXEC mode using the console is cisco2
The password to allow telnet access to the router is cisco3
IPV4 addresses mast be configured as follows:
Ethernet network 209.165.201.0/27 – router has fourth assignable host address in subnet
Serial network is 192.0.2.176/28 – router has last assignable host address in the subnet.
Interfaces should be enabled.
Router protocol is RIPV2
Attention:
In practical examinations, please note the following, the actual information will prevail.
1. Name of the router is xxx
2. Enable. secret password is xxx
3. Password In access user EXEC mode using the console is xxx
4. The password to allow telnet access to the router is xxx
5. IP information
Answer: Router>enable
Explanation:
Router#config terminal
Router(config)#hostname R2
R2(config)#enable secret cisco
R2(config)#line console 0
R2(config-line)#password cisco2
R2(config-line)#exit
R2(config)#line vty 0 4
R2(config-line)#password cisco3
R2(config-line)#login
R2(config-line)#exit
R2(config)#interface fa0/0
R2(config-if)#no shutdown
R2(config-if)#ip address 209.165.201.4 255.255.255.224 R2(config)#interface s0/0/0
R2(config-if)#ip address 192.0.2.190 255.255.255.240 R2(config-if)#no shutdown
R2(config-if)#exit
R2(config)#router rip
R2(config-router)#version 2
R2(config-router)#network 209.165.201.0
R2(config-router)#network 192.0.2.176
R2(config-router)#end
R2#copy run start