Refer to the exhibit.
Cisco Unified Communications Manager Express has been partially configured to support 6 IP phones and 12 directory numbers. The Cisco Unified Communications Manager Express will use the IP address 10.1.130.1/24. Which two elements of the configuration are missing from the command output and need to be added so that phones do not auto-register, but can manually register with Cisco Unified Communications Manager Express? (Choose two.)
A.
ip address 10.1.130.1
B.
no reg-ephone
C.
create profile
D.
ip source-address 10.1.130.1
E.
create cnf-files
F.
no auto-reg-ephone
Explanation:
To identify the IP address and port through which IP phones communicate with a CiscoUnifiedCME router, use the ip source-address command in telephony-service or group configuration mode. This command enables a router to receive messages from CiscoUnifiedIPphones through the specified IP address and port. The CiscoUnifiedCME router cannot communicate with CiscoUnifiedCME phones if the IP address of the port to which they are attached is not configured.
Normally when you configure basic telephony-service parameters, then phone can register with CME although no DN will be assigned to them. You can disable this by using the no auto-reg- ephone command. After this command the phone which will try to register will receive message “Registration Rejected: No configuration entry…..”.. When automatic registration is blocked, CiscoUnifiedCME records the MAC addresses of phones that attempt to register but cannot because they are blocked.
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/command/reference/cme_a1ht.html#wp 1031242