You have installed a FWSM in your Catalyst 6500 switch, initialized it in the switch, configured
switch VLANs, and configured the module interfaces; however, you are unable to establish
outbound connections. You check your configuration and find that you have correctly configured
the six basic commands (nameif, interface, ip address, nat, global, and route). What could be the
cause of the problem?
A.
You need an ACL for the inside interface.
B.
You need an ACL for the outside interface.
C.
You have not configured a switch VLAN for the inside interface.
D.
The MSFC is configured as a connected router only on the outside interface.