Study the exhibit carefully. When the show failover command has returned this output, what is the
problem with the failover configuration?
fw2# show failover
Failover ON
Cable status: Other side not connected
Failover unit Primary
Failover LAN Interface: N/A-Serial-based failover enabled
Unit Poll frequency 15 seconds, holdtime 45 seconds
Interface Poll frequency 15 seconds
Interface Policy 1
Monitored Interfaces 3 of 250 maximum
Last Failover at: 13:21:38 UTC Dec 10 2004
This host: Primary-Active
Active time: 200(sec)
Interface outside (192.168.2.2): Normal (Waiting)
Interface inside (10.0.2.1): Normal (Waiting)
Interface dmz (172.16.2.1): Normal (Waiting) Other host: Secondary-Not detected
Active time: O(sec)
Interface outside (192.168.2.7): Unknown (Waiting)
Interface inside (10.0.2.7): Unknown (Waiting)
Interface dmz (172.16.2.7): Unknown (Waiting)
Stateful Failover Logical Update Statistics Link: Unconfigured
A.
The poll frequency is set too high to detect the secondary failover security appliance.
B.
The failover cable is not connected to the secondary failover security appliance
C.
There is no problem; the timer that detects the secondary failover security appliance has not
expired.
D.
The LAN-based failover interface has been shut down on the security appliance.