Which three of these steps are used to initialize and verify the Cisco ASA AIP-SSM? (Choose
three.)
A.
connect a management station directly to the AIP-SSM console port via a serial cable
B.
access the Cisco IDM from a management station using http://sensor-ip-address
C.
use the ASA#show module command to verify the AIP-SSM status
D.
use the ASA#telnet sensor-ip-address command to access the AIP-SSM to setup the basic
configuration on the sensor
E.
use the sensor#setup command to configure the basic sensor settings
F.
use the ASA#session 1 command to access the AIP-SSM CLI
Explanation: