Refer to the exhibit. The Cisco ASA is operating in transparent mode. What is required on the Cisco ASA so that R1 and R2 can form OSPF neighbor adjacency?
A.
Map the R1 and R2 MAC address in the Cisco ASA MAC address table using the mac-address- table static if_name MAC_address command.
B.
Configure OSPF stateful packet inspection using MPF.
C.
Apply an EtherType ACL to the inside and outside interfaces to permit OSPF multicast traffic.
D.
Apply an extended ACL to the inside and outside interfaces to permit OSPF multicast traffic.
E.
Enable Advanced Application Inspection using MPF.