Which of the following would cause this failure?

Using the WLSE, you are trying to push out a configuration job to a standalone access point, but the job does not start. Which of the following would cause this failure?

Using the WLSE, you are trying to push out a configuration job to a standalone access point, but the job does not start. Which of the following would cause this failure?

A.
invalid parameter in the template

B.
incorrect SNMP communities on the access point

C.
pop-up blocker enabled in the browser

D.
unsupported version of IOS firmware in the access point



Leave a Reply 0

Your email address will not be published. Required fields are marked *