When using Modular QoS CLI to classify packets arriving from a specific MAC address, which command should you use?

When using Modular QoS CLI to classify packets arriving from a specific MAC address, which command should you use?

When using Modular QoS CLI to classify packets arriving from a specific MAC address, which command should you use?

A.
Match mac

B.
Match source

C.
Match source-mac

D.
Match source-address

E.
Match source-address mac

Explanation:

Match source-address mac mac-address command classifies packets based on the source MAC address. This classification oprion can only be used on interfaces using MAC addresses (e.g. Ethernet, FastEthernet).
Reference: Introduction to IP QoS p.8-27



Leave a Reply 0

Your email address will not be published. Required fields are marked *