Refer to the exhibit. You have a Cisco WLC 2106 with two APs connected on the PoE ports. You have configured the internal DHCP server of the Cisco WLC with a scope to assign IP addresses to APs and wireless clients alike. However, the APs are not able to join the controller. Based on the output of the show commands, what should you do to fix the problem?
Select the best response.
Exhibit:
A.
Configure AP-manager and management interfaces to have VLAN 10 as native.
B.
Configure only the managementinterface to have VLAN 10 as native.
C.
Correct the DHCP server IP address for management interface.
D.
Connect the APs to non-PoE ports, because the PoE ports are meant for phones only.
E.
Create two different DHCP scopes, because the same scope cannot be used for APs and clients.