Refer to the exhibit. The GigabitEthernet 0/1 interfaces of Switch1 and Switch2 have been
properly configured to support trunking. On the basis of the VTP configuration commands that
have been issued on Switch1, which command set is required to properly configure VTP on
Switch2?
A.
Switch2# conf t Switch2(config)# vtp mode clientSwitch2(config)# version 2Switch2(config)# vtp
domain eng_groupSwitch2(config)# vtp password switch2
B.
Switch2# conf t Switch2(config)# vtp mode serverSwitch2(config)# vtp domain
eng_groupSwitch2(config)# vtp password switch1
C.
Switch2# conf t Switch2(config)# vtp mode serverSwitch2(config)# version 2Switch2(config)#
vtp domain eng_groupSwitch2(config)# vtp password switch1
D.
Switch2# conf t Switch2(config)# vtp mode clientSwitch2(config)# version 2Switch2(config)# vtp
domain eng_groupSwitch2(config)# vtp password switch1