Refer to the exhibit. LACP has been configured on Switch1 as shown. Which is the correct
command set to configure LACP on Switch2?
A.
Switch2# configure terminalSwitch2(config)# interface range gigabitethernet3/1 –
2Switch2(config-if)# channel-group 5 mode desirable
B.
Switch2# configure terminalSwitch2(config)# interface range gigabitethernet3/1 –
2Switch2(config-if)# channel-group 5 mode on
C.
Switch2# configure terminalSwitch2(config)# interface range gigabitethernet3/1 –
2Switch2(config-if)# channel-group 5 mode auto
D.
Switch2# configure terminalSwitch2(config)# interface range gigabitethernet3/1 –
2Switch2(config-if)# channel-group 5 mode passive