what can be determined?

Refer to the exhibit. You have configured an interface to be an SVI for Layer 3 routing capabilities. Assuming that all VLANs have been correctly configured and based on the configuration example shown, what can be determined?

Select the best response.

Refer to the exhibit. You have configured an interface to be an SVI for Layer 3 routing capabilities. Assuming that all VLANs have been correctly configured and based on the configuration example shown, what can be determined?

Select the best response.

A.
Interface gigabitethernet0/2 will be excluded from Layer 2 switching and enabled for Layer 3 routing.

B.
The command switchport autostate exclude should be entered in global configuration mode, not sub-interface mode, to enable a Layer 2 port to be configured for Layer 3 routing.

C.
The configured port is excluded in the calculation of the status of the SVI.

D.
The interface is missing IP configuration parameters; therefore, it will only function at Layer 2



Leave a Reply 1

Your email address will not be published. Required fields are marked *


hork

hork

ya um ya cant issue switchport commands on an svi nooblets. bad thing about cheaters like testking is they dont actually know the tech behind the questions they steal

hork!