During routine maintenance, GigabitEthernet1/0/1 onDSW1 was shut down. All other interfaces were up.
DSW2 became the active HSRP device for VLAN 101 as desired. However, after GigabitEthernet1/0/1 on
DSW1 was reactivated, DSW1 did not become the active router for VLAN 101 as desired. What needs to be
done to make the group for VLAN 101 function properly?
A.
Enable preempt in the VLAN 101 HSRP group on DSW1
B.
Disable preempt in the VLAN 101 HSRP group on DSW2’s
C.
In the VLAN 101 HSRP group on DSW1, decrease the priority value to a value that is less than the priority
value configured in the VLAN 101 HSRP group on DSW2
D.
Decrease the decrement value in the track commandfor the VLAN 101 HSRP group on DSW1’s to a
values less that the value in the track command forthe VLAN 101 HSRP group on DSW2