Which two steps are necessary to configure inter-VLAN routing between multilayer switches?
(Choose two.)
A.
Configure a dynamic routing protocol.
B.
Configure SVI interfaces with IP addresses and subnet masks.
C.
Configure access ports with network addresses.
D.
Configure switch ports with the autostate exclude command.
E.
Document the MAC addresses of the switch ports.
Explanation:
To be honest configuration of dynamic routing protocol is not necessary to enable inter VLAN
routing between multilayer switches. The static routing would be enough. But as question requires
choosing two answers you are constrained to choose answer A beside the obvious answer B.
Reference:
http://www.cisco.com/en/US/tech/tk389/tk815/technologies_configuration_example09186a008019
e74e.shtml