Refer to the exhibit. Which two statements are true about the output from the “show standby vlan 50” command? (Choose two)
A.
Catalyst_A is load sharing traffic in VLAN 50.
B.
Hosts using the default gateway address of 192.168.1.2 will have their traffic sent to Catalyst_A.
C.
The command standby 1 preempt was added to Catalyst_A.
D.
Hosts using the default gateway address of 192.168.1.1 will have their traffic sent to 192.168.1.11 even after Catalyst_A becomes available again.
Explanation:
The output shows that the Catalyst_A switch is the active router for HSRP group 1 and the standby router for HSRP group 2 on interface VLAN 50. This means that another switch is the active router for HSRP group 2 on interface VLAN 50 -> A is correct, Catalyst_A is load sharing traffic in VLAN 50.
B is not correct, only hosts using the default gateway address of 192.168.1.1 will have their traffic sent to Catalyst_A
From the output, we notice that there is a line showing that Local State is Active, priority 200 may preempt. This indicates the command standby 1 preempt was added to Catalyst_A. If the active router (this router) fails, another router takes over its active role. The original active router is not allowed to resume the active role when it is restored until the new active router fails. Pre-empting allows a higher-priority router to take over the active role immediately.
Explanation from certprepare.com