Refer to the exhibit. On the basis of the information that is generated by the show commands, which two EtherChannel statements are true? (Choose two.)
A.
Interfaces FastEthernet 0/1 and 0/2 have been configured with the channel-group 1 mode desirable command.
B.
Interfaces FastEthernet 0/3 and 0/4 have been configured with the no switchport command.
C.
Interface Port-Channels 1 and 2 have been assigned IP addresses with the ip address commands.
D.
Port-Channels 1 and 2 are providing two 400 Mbps EtherChannels.
E.
Port-Channels 1 and 2 are capable of combining up to 8 FastEthernet ports to provide full-duplex bandwidth of up to 16 Gbps between a switch and another switch or host.
F.
Switch SW1 has been configured with a Layer 3 EtherChannel.
How do you know that the port-channel was set to desirable based on this output? I think we would need to see the output of ‘show etherchannel detail’