which command is used within a route policy to call another route policy?

When configuring Cisco IOS XR route policy nesting, which command is used within a route policy
to call another route policy?

A.
Apply

B.
Continue

C.
Jump

D.
Go to

E.
Call

Explanation:

http://www.cisco.com/en/US/docs/ios_xr_sw/iosxr_r3.7/routing/command/reference/rr37plcy.html
Examples
In the following example, the policy CustomerIn applies the route-policy SetLocalPref to
conditionally set the local preference on a route. The parameters 20, 30, 40, and 50 are passed to
the parameterized policy SetLocalPref, where the local preference is set to:
•20, if the community 217:20 is present in the route
•30, if the community 217:30 is present in the route
•40, if the community 217:40 is present in the route
•50, if the community 217:50 is present in the route
RP/0/RP0/CPU0:router(config)# route-policy SetLocalPref ($lp0, $lp1, $lp2, $lp3,
$lp4)
RP/0/RP0/CPU0:router(config-rpl)# if community matches-any ($lp0:$lp1)then
RP/0/RP0/CPU0:router(config-rpl-elseif)# set local-preference $lp1
RP/0/RP0/CPU0:router(config-rpl-elseif)# elseif community matches-any ($lp0:$lp2)
then
RP/0/RP0/CPU0:router(config-rpl-elseif)# set local-preference $lp2
RP/0/RP0/CPU0:router(config-rpl-elseif)# elseif community matches-any ($lp0:$lp3)
then
RP/0/RP0/CPU0:router(config-rpl-elseif)# set local-preference $lp3
RP/0/RP0/CPU0:router(config-rpl-elseif)# elseif community matches-any ($lp0:$lp4)
then
RP/0/RP0/CPU0:router(config-rpl-elseif)# set local-preference $lp4

RP/0/RP0/CPU0:router(config-rpl-elseif)# endif
RP/0/RP0/CPU0:router(config-rpl)# end-policy
RP/0/RP0/CPU0:router(config)# route-policy CustomerIn($cust)
RP/0/RP0/CPU0:router(config-rpl)# apply SetLocalPref ($cust, 20, 30, 40, 50)
RP/0/RP0/CPU0:router(config-rpl)# end-policy
RP/0/RP0/CPU0:router(config)# route-policy Cust_217
RP/0/RP0/CPU0:router(config-rpl)# apply CustomerIn(217)
RP/0/RP0/CPU0:router(config-rpl)# end-policy