Which of the following are methods EIGRP uses to initially populate (seed) its EIGRP
topology table, before learning topology data from neighbors? (Choose two.)
A.
By adding all subnets listed by the show ip route connected command
B.
By adding the subnets of working interfaces over which static neighbors have been
defined
C.
By adding subnets redistributed on the local routerfrom another routing source
D.
By adding all subnets listed by the show ip route static command
Explanation:
Other than the two listed correct answers, the local router also adds connected routes for which the network
command matches thr corresponding interfaces, so itmay not add connected routes. Also, EIGRP does not
add static routes to the EIGRP topology table, unless those routes are redistributed