Refer to the exhibit.
What two statements are true? (Choose two.)
A.
Interface FastEthernet 0/0 was configured with the ipv6 ospf 1 area 1 command.
B.
OSPF version 2 has been enabled to support IPv6.
C.
The IP address of the backup designated router (BDR) is FE80::205:5FFF:FED3:5808.
D.
The output was generated by the show ip interface command.
E.
The router was configured with the commands: router ospf 1 network 172.16.6.0 0.0.0.255 area
1
F.
This is the designated router (DR) on the FastEthernet 0/0 link.
Explanation:
OSPFv3 supports IPv6. The configuration of OSPFv3 is not a subcommand mode of the router
ospf command as it is in OSPFv2 configuration. For example, instead of using the network area
command to identify networks that are part of the OSPFv3 network, the interfaces are directly
configured to specify that IPv6 networks are part of the OSPFv3 network.The following describes the steps to configure OSPF for IPv6:
There are several commonly used OSPFv3 show commands, including the show ipv6 ospf [
process-id] [area-id] interfacee [interface] command.
