Refer to the exhibit.
How would you confirm on R1 that load balancing is actually occurring on the default-network (0.0.0.0)?
A.
Use ping and the show ip route command to confirm the timers for each default network resets
to 0.
B.
Load balancing does not occur over default networks; the second route will only be used for
failover.
C.
Use an extended ping along with repeated show ip route commands to confirm the gateway of
last resort address toggles back and forth.
D.
Use the traceroute command to an address that is not explicitly in the routing table.
Explanation:
The most simple method to test load balancing is to use the “traceroute” command. If load
balancing is working correctly, we will see different paths to reach the destination each time we
use that command.
Unknown address will be routed via the default-network 0.0.0.0 so we must use an address that is
not explicitly in the routing table.