Drag the characteristics on the left to the appropriate column heading (VSAN or Zoning) on the right.

http://www.cisco.com/en/US/products/ps5989/products_configuration_guide_chapter09186a0080662ce3.html#wp1114009

New Updated 642-997 Exam Questions from PassLeader 642-997 PDF dumps! Welcome to download the newest PassLeader 642-997 VCE dumps: http://bit.ly/1Q4zq4D (137 Q&As)

Keywords: 642-997 exam dumps, 642-997 exam questions, 642-997 VCE dumps, 642-997 PDF dumps, 642-997 practice tests, 642-997 study guide, 642-997 braindumps, Implementing Cisco Data Center Unified Fabric (DCUFI) Exam

NEW QUESTION 101
If you are using NAT in your data center, which load balancing would you be likely to use within your GLBP configuration?

A. none
B. round-robin
C. host dependent
D. weighted

Answer: C

NEW QUESTION 102
Which command specifies a load-balancing method based on the MAC address of a host where the same forwarder is always used for a particular host while the number of GLBP group members remains unchanged?

A. load-balancing host-dependent
B. load-balancing mac-pinning
C. load-balancing round-robin
D. load-balancing weighted

Answer: A

NEW QUESTION 103
Which feature allows routing protocols to remain in the data path during a supervisor failover?

A. Cisco Nonstop Forwarding
B. Cisco Stateful Switchover
C. Cisco Express Forwarding
D. Cisco Route Processor Redundancy

Answer: A

NEW QUESTION 104
Which two functions are enabled when you set up vPC+ at the FabricPath edge? (Choose two.)

A. the ability to attach Cisco Fabric Extenders in FEX active/active mode
B. the ability to stop all Layer 3 egress traffic
C. the ability to attach servers to edge switches with port-channel teaming
D. the ability to attach additional Classic Ethernet switches in vPC+ mode

Answer: AC

NEW QUESTION 105
How does addition of bandwidth between spine and leaf switches in a FabricPath architecture get utilized?

A. Links between the same set of switches are automatically added to a port channel.
B. Adding additional bandwidth is handled dynamically using the 802.1AX protocol.
C. Traffic is load shared automatically across the available paths to the destination.
D. FabricPath uses hardware bonding of physical interfaces to form higher-speed links.

Answer: C

NEW QUESTION 106
Which two advantages does FabricPath have over Spanning Tree in implementing a loop-free network topology design? (Choose two.)

A. Blocked links can be brought in to service if active links fail.
B. Convergence times are faster.
C. Multipath forwarding is supported for unicast and multicast Layer 2 and Layer 3 traffic.
D. Unknown unicast addresses are flooded in through the originating port.

Answer: BC

NEW QUESTION 107
Which four statements about reserved VLANs in Cisco NX-OS are true? (Choose four.)

A. The range of reserved VLANs cannot be changed.
B. The number of reserved VLANs is 96.
C. A change to the range of reserved VLANs can be performed only in the VDC default.
D. A write-erase procedure restores the default reserved VLAN range.
E. The number of reserved VLANs is 128.
F. A reload is needed for changes to take place.
G. The configuration must be saved for changes to take place.

Answer: CEFG

NEW QUESTION 108
Which two RFCs are supported by Cisco NX-OS devices for OSPFv2? (Choose two.)

A. RFC 2238
B. RFC 1918
C. RFC 1583
D. RFC 2453
E. RFC 2740

Answer: AC

NEW QUESTION 109
Which action limits the maximum number of routes that are allowed in the routing table?

A. Use a filter BGP.
B. Use only static routes.
C. Use the maximum routes command inside address family.
D. Use a route map to filter routes.

Answer: C

NEW QUESTION 110
Which three options of encryption are supported in PIM hello messages? (Choose three.)

A. cleartext
B. DES-SHA1
C. DES-CBC3-SHA
D. Cisco Type 7
E. RC4-SHA
F. 3DES

Answer: ADF

NEW QUESTION 111
Which command is used to associate EID-to-RLOC for a LISP site?

A. #feature lisp
B. #ipv6 lisp itr
C. #ip lisp database-mapping
D. #ip lisp itr map-resolver

Answer: C

NEW QUESTION 112
In OTV, how are the VLANs split when a site has two edge devices?

A. They are configured manually by user.
B. They are split in half among each edge device.
C. They are split as odd and even VLAN IDs on each edge device.
D. It is not possible to have two edge devices in same site.

Answer: C

NEW QUESTION 113
Which statement about the MPLS feature set is true?

A. It is not license dependent.
B. It can be installed from any VDC.
C. It can be enabled only in the default VDC.
D. It must be installed from the default VDC.

Answer: D

NEW QUESTION 114
……

Download the newest PassLeader 642-997 dumps from passleader.com now! 100% Pass Guarantee!

642-997 PDF dumps & 642-997 VCE dumps: http://bit.ly/1Q4zq4D (137 Q&As)

ATTENTION PLEASE!!!

The 642-997 Exam Has Retired, the New Exam is 300-165 Now!

New 300-165 Exam Questions and Answers Updated Recently (11/Oct/2017):

NEW QUESTION 175
Which option accurately describes the implementation of Fabre Channel domain IDs?

A. Are assigned on a peer-switch basis
B. Are assigned on a per-line card basis
C. Must be the dame on all on the Fabre Channel switch in the fabric
D. Must be unique on all the Fibre Channel switches in the fabric

Answer: A

NEW QUESTION 176
Refer to the following codes. Which option is expected outcome on the configured switch?
Switch(config)# snmp-server user all enforcePriv

A. The switch enforces SNMP message encryption for all users
B. The switch responds with an authorization error for any SNMPv3 PDU requests that use a security level parameter
C. SNMP requires encryption for all incoming requests
D. The switch enforces SNMP message encryption for the user all

Answer: C

NEW QUESTION 177
You have a vPC configuration with two functional peers. The peer link is up and the peer-link feature is restricted the spanning-tree operations in the configuration? (Choose two.)

A. The primary and secondary switch generate and process BPDUs
B. vPC imposes a rules that the peer link is always blocking
C. vPC removes some VLANs from the spanning tree form the spanning tree for vPC use
D. vPC requires the peer link to remain in the forwarding states

Answer: AD

NEW QUESTION 178
You have a Cisco MDS switch that uses port channel. You must ensure that frames between the source and the destination follow the same links for a specific flow. Subsequent flows can use a different link, which load-balancing method do you use?

A. Source-destination-ip
B. Source-destioation-port
C. Flow
D. Source id-destination id-oxid

Answer: C

NEW QUESTION 179
Within the vPC configuration of the 7K’s, the command peer switch is configured. What is the result of enabling the command?

A. Both vPC peers use the same STP root ID.
B. The Vpc primary switch (7K-4 in this case) also serves as the STP root to improve vPC convergence.
C. The vPC secondary switch (7K-3 in this case) server as the STP root to improve vPC performance.
D. Allow 7K-3 to act as the active HSRP gateway for packets that are addressed to the MAC address of 7K-4.
E. Automatically disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched though the vPC peer gateway router.
F. Enable faster convergence of ARP tables after the vPC peer link flaps.

Answer: B

NEW QUESTION 180
Refer to the following codes. Which result of the configuration snippet is true?
Vlan access-map map
Match mac address acl01
Action forward
Statistics per-entry
Vlan filter map vlan-list

A. A VACL map in applied to VLAN 101 and VLAN 200
B. VACL acl is applied to VLAN 100 through 200
C. Acl is applied to all of the VLANs on the switch
D. Global statistics are provided for the ACL map

Answer: A

NEW QUESTION 181
Refer to the following codes. You have a Cisco Nexus 7010 switch named N7k-1.
N7k-1# show runing-config fabricpath
……
Fabricpath switch-id 11
Vpc domain 11
Fabricpath switch-id 1100
Which command set should you run on a neighboring Cisco Nexus 7010 swith to estabish a vPC+ environment that includes N7k-1?

A. Fabricpath switch-id 11 Vpc domain 11 Fabricpath switch-id 1100
B. Fabricpath switch-id 12 Vpc domain 11 Fabricpath switch-id 1100
C. Fabricpath switch-id 12 Vpc domain 11 Fabricpath switch-id 1200
D. Fabricpath switch-id 11 Vpc domain 12 Fabricpath switch-id 1101

Answer: A

NEW QUESTION 182
Refer to the following codes. Which description of the output is true?
……

A. The default map-catch limit is used.
B. PETR is disable.
C. The table output apply to the default VRF.
D. The switch acts as an IPv4 LISP ETR.

Answer: B

NEW QUESTION 183
When configure HSPR on IPv6 enabled interface, which two configuration is correct?

A. switchA(config-if)?standbyt 6 preempt
B. switchA(config-if)?hsrp;
C. switchA(config-if)ff key 6
D. switchA(config-if)?hsrp version 2
E. switchA(config-if)B priority

Answer: B

NEW QUESTION 184
You have a Cisco FabricPath network. You must implement Vpc+ for a downstream switch. Which three actions should you preform? (Choose three.)

A. Configure the upstream switch to use PAgP in EtherChannel
B. Establish a peer link between the peer switch
C. Connect the downstream switch to a 10-Gb port
D. Configure a peer keep alive between the peer switches
E. Configure the switch ID on the peer switches
F. Configure the down switch to use PAgP on EtherChannel

Answer: BCD

NEW QUESTION 185
You have a Cisco Fabric Path network, you must extend the network to support more than 18 million segment, what should you do?

A. Enable the interface feature and configure the VLAN IDs.
B. Enable the nv overlay feature and configure the segment IDs.
C. Enable the vn-segment-vlan-based feature and configure segment IDs.
D. Enable the FabricPath feature and configure the VLAN IDs.

Answer: D

NEW QUESTION 186
……

P.S. These New 300-165 Exam Questions Were Just Updated From The Real 300-165 Exam, You Can Get The Newest 300-165 Dumps In PDF And VCE From — https://www.passleader.com/300-165.html (195q VCE and PDF)

Good Luck!