What command should you invoke to correct the issue?

In some situations, switches may not play nicely with a Check Point Cluster and it is necessary to
change from multicast to broadcast. What command should you invoke to correct the issue?

In some situations, switches may not play nicely with a Check Point Cluster and it is necessary to
change from multicast to broadcast. What command should you invoke to correct the issue?

A.
This can only be changed via GuiDbEdit.

B.
set ccp broadcast

C.
cphaconf set_ccp broadcast

D.
cpha_conf set ccp broadcast

Explanation:

Show Hint

Leave a Reply 1

Your email address will not be published. Required fields are marked *

Sidza

Sidza

To change the CCP mode to broadcast mode (on all cluster interfaces), run:

Important Note: When setting CCP mode to Broadcast, the cluster member stops sending IGMP membership packets. As a result, if IGMP Snooping is enabled on the switch, the CCP packets will not be forwarded to the peer members.

[Expert@HostName]# cphaconf set_ccp broadcast

Reply