You install and deploy SecurePlatform with default settings. You allow Visitor Mode in the Remote Access properties of the Gateway object and install policy, but SecureClient refuses to connect.
What is the cause of this?
A.
Set Visitor Mode in Policy > Global Properties / Remote-Access / VPN – Advanced.
B.
Office mode is not configured.
C.
The WebUI on SecurePlatform runs on port 443 (HTTPS). When you configure Visitor Mode it cannot bind to default port 443, because it’s used by another program (WebUI). You need to change the WebUI port, or run Visitor Mode on a different port.
D.
You need to start SSL Network Extender first, than use Visitor Mode.