What must happen after authentication that allows the client to connect to the Security Gateway’s VPN domain?

You have configured SNX on the Security Gateway. The client connects to the Security Gateway
and the user enters the authentication credentials. What must happen after authentication that
allows the client to connect to the Security Gateway’s VPN domain?

You have configured SNX on the Security Gateway. The client connects to the Security Gateway
and the user enters the authentication credentials. What must happen after authentication that
allows the client to connect to the Security Gateway’s VPN domain?

A.
SNX modifies the routing table to forward VPN traffic to the Security Gateway.
B. An office mode address must be obtained by the client.

C.
The SNX client application must be installed on the client.

D.
Active-X must be allowed on the client.

Show Hint

Leave a Reply 4

Your email address will not be published. Required fields are marked *

OBM

OBM

This is actually D. From the product guide.

Once the end user has connected to a server, the thin client is downloaded as an ActiveX component, installed, and then used to connect to the corporate network using the SSL protocol.

Reply