Which of the following commands can be used in CLISH to configure the speed and duplex settings of an Ethernet interface and will survive a reboot?

You are the Security Administrator for MegaCorp. A Check Point firewall is installed and in use on
a platform using GAiA. You have trouble configuring the speed and duplex settings of your
Ethernet interfaces. Which of the following commands can be used in CLISH to configure the
speed and duplex settings of an Ethernet interface and will survive a reboot? Give the BEST
answer.

You are the Security Administrator for MegaCorp. A Check Point firewall is installed and in use on
a platform using GAiA. You have trouble configuring the speed and duplex settings of your
Ethernet interfaces. Which of the following commands can be used in CLISH to configure the
speed and duplex settings of an Ethernet interface and will survive a reboot? Give the BEST
answer.

A.
ethtool
B. set interface <options>

C.
mii_tool

D.
ifconfig -a

Show Hint

Leave a Reply 3

Your email address will not be published. Required fields are marked *

Ben

Ben

B

set interface

From Checkpoint:
Important – After using CLI commands to add, configure or delete features, you must run the save config command. This makes sure that the new configuration settings remain after reboot.

Reply