Is State Synchronization working properly between the two members?

State Synchronization is enabled on both members in a cluster, and the Security Policy is successfully installed. No protocols or services have been unselected for "selective sync".
The following is the fw tab -t connections -s output from both members. exhibit Is State Synchronization working properly between the two members?

State Synchronization is enabled on both members in a cluster, and the Security Policy is successfully installed. No protocols or services have been unselected for “selective sync”.
The following is the fw tab -t connections -s output from both members.

Is State Synchronization working properly between the two members?

A.
Members A and B are synchronized, because ID for both members is identical in the connections table.

B.
The connections-table output is incomplete. You must run the cphaprob state command, to determine if members A and B are synchronized.

C.
Members A and B are not synchronized, because #PEAK for both members is not close in the connections table.

D.
Members A and B are synchronized, because #SLINKS are identical in the connections table.

E.
Members A and B are not synchronized, because #VALS in the connections table are not close.



Leave a Reply 1

Your email address will not be published. Required fields are marked *


seenagape

seenagape

Correct answer is