Which CLI tool helps on verifying proper ClusterXL sync?

maya

Isn’t answer D?

Reply

Chris

no cpahprob stat (actually state) Shows you the state of the Cluster members load sharing mode
like that

Cluster mode: Load sharing (Multicast)

Number Unique Address State
1 (local) 30.0.0.1 active
2 30.0.0.2 active

fw ctl pstat Displays Information about the sync
Sync:
Version: new
Status: Able to Send/Receive sync packets
Sync packets sent:
total : 466729198, retransmitted :241305, retrans reqs : 6089, acks : 809
Sync packets received:
total : 77283541, were queued : 6715, dropped by net : 6079
retrans reqs : 37462, received 221 acks
retrans reqs for illegal seq : 2
dropped updates as a result of sync overload: 3
Delta Sync memory usage: currently using XX KB mem
Callback statistics: handled 165 cb, average delay : 3, max delay : 34
Number of Pending packets currently held: 1
Packets released due to timeout: 18

Reply

Tim

cphaprob state and fw ctl pstat both do…at least, if you were troubleshooting you would check both commands.

fw ctl pstat shows more information, but won’t show you if you are at Active/Standby or something different, so the answer is probably better suited to D

reason: if you had a scenario of Active/Down and you issued the fw ctl pstat on the Active member, everything would appear ok. cphaprob state issued on that same member would immediately tell you there was a problem by displaying the other member as Down…

Reply

Josh

Maybe D ist the better answer to the following question:
Which CLI tool gives information about a cluster concerning readiness for failover?
For proper ClusterXL sync prefer answer C.

Reply