You have three Gateways in a mesh community. Each gateway’s VPN Domain is their internal
network as defined on the Topology tab setting “All IP Addresses behind Gateway based on
Topology information.” You want to test the route-based VPN, so you created VTIs among the
Gateways and created static route entries for the VTIs. However, when you test the VPN, you find
out the VPN still go through the regular domain IPSec tunnels instead of the routed VTI tunnels.
What is the problem and how do you make the VPN to use the VTI tunnels?
A.
Route-based VTI takes precedence over the Domain VPN. Troubleshootthe static route entries
to insure that they are correctly pointing to the VTI gateway IP
B.
Domain VPN takes precedence over the route-based VTI. To make the VPN go through VTI,
remove the Gateways out of the mesh community and replace with a star community
C.
Route-based VTI takes precedence over the Domain VPN. To make the VPN go through VTI,
use dynamic-routing protocol like OSPF or BGP to route the VTI address to the peer instead of
static routes
D.
Domain VPN takes precedence over the route-based VTI. To make the VPN go through VTI,
use an empty group object as each Gateway’s VPN Domain