Which network component is the default target for IPMP probe-based Failure detection?
A.
the default router
B.
any nongateway system on the same subnet
C.
any group interface with a test address
D.
the first responder to the in.mpathd broadcast request
Explanation:
How to Manually Specify Target Systems for Probe-Based Failure Detection
1. Add a route to a particular host to be used as a target in probe-based failure detection.
$ route -p add -host destination-IP gateway-IP -staticwhere destination-IP and gateway-IP are IPv4 addresses of the host to be used as a target. For
example, you would type the following to specify the target system 192.168.10.137, which is on
the same subnet as the interfaces in IPMP group itops0:
$ route -p add -host 192.168.10.137 192.168.10.137 -static
This new route will be automatically configured every time the system is restarted. If you want to
define only a temporary route to a target system for probe-based failure detection, then do not use
the -p option.
2.Add routes to additional hosts on the network to be used as target systems.
A