Which command most you use to determine if all interfaces in the group support linkbased detection?

You added three interfaces to an IPMP group. You now want to review the failure detection
modes. Which command most you use to determine if all interfaces in the group support linkbased detection?

A.
ipadm show-ifprop

B.
dlstat show-link

C.
dladm show-link

D.
ipmpstat –i

Explanation:
Link-Based Failure Detection
Link-based failure detection is always enabled, provided that the interface supports this type of
failure detection.
To determine whether a third-party interface supports link-based failure detection, use the
ipmpstat -i command. If the output for a given interface includes an unknown status for its LINK
column, then that interface does not support link-based failure detection. Refer to the
manufacturer’s documentation for more specific information about the device.