You added an interface to the IPMP group ipmp0 with the following commands:
# ipadm create-ip net4
# ipadm add-ipmp –i net4 ipmp0
Which statement regarding the newly added interface is correct?
A.
Link state failure detection will not occur.
B.
Probe-based failure detection will not occur.
C.
Without a data IP address, it cannot become active.
D.
These changes will be lost when the system is booted.
Explanation:
B: Link state failure detection is the default.
C: An IP address is required.
Note:
* The in.mpathd daemon handles the following types of failure detection:
/ Probe-based failure detection, of two types:
No test addresses are configured (transitive probing).
Test addresses are configured.
/ Link-based failure detection, if supported by the NIC driver
C not correct
ipadm create-ip net0
ipadm add-ipmp -i net0 ipmp0
ipadm show-if
IFNAME CLASS STATE ACTIVE OVER
lo0 loopback ok yes —
ipmp0 ipmp ok yes net0 net3
net0 ip ok yes —
net3 ip ok yes —
net7 ip down no —
clprivnet0 ip ok yes —
ipadm
NAME CLASS/TYPE STATE UNDER ADDR
clprivnet0 ip ok — —
ipmp0 ipmp ok — —
ipmp0/v4add1 static ok — 172.24.1.175/24
lo0 loopback ok — —
lo0/v4 static ok — 127.0.0.1/8
lo0/v6 static ok — ::1/128
net0 ip ok ipmp0 —
net3 ip ok ipmp0 —
net3/test static ok — 172.24.1.176/24
net7 ip down — —
Only B is correct
Only B, if no test address link based will be use so probe-based failure detection will not occur.
Passed Oracle Solaris 11 1Z0-822 exam last week! Scored 85% (the passing score is 70% now)!
I had 80 questions, questions were mainly on SMF, IPS, ZFS, Configuring the Network, Securing the Oracle Solairs 11 O/S, Installing Oracle Solaris 11 on multiple hosts…etc.
The 1Z0-822 exam has been revised since 2016, I do recommend you to learn the latest 1Z0-822 dumps here:
http://www.oraclebraindump.com/?s=1Z0-822
(Those are part of PassLeader 1Z0-822 dumps, suggest to get its full version 1Z0-822 dumps with VCE and PDF.)
Good Luck!