Which is NOT likely reason for the failure?

You are looking at the event log of the responding device and it says Rejected an initial Phase 1 packet from an unrecognized peer gateway Which is NOT likely reason for the failure?

You are looking at the event log of the responding device and it says Rejected an initial Phase 1 packet from an unrecognized peer gateway Which is NOT likely reason for the failure?

A.
Local IDmisconfigured

B.
Gateway addressmisconfigured

C.
Outing Interfacemisconfigured

D.
Security proposalsmisconfigured

Explanation:

According to junipers knowledgebasethere are several possible causes for this:*This can be an indication that the IKE ID of theNetScreen-Remote client does not match the IKE ID of the Dial Up User configuration on theNetScreengateway.Resolution:Verify the IKE ID of bothNetScreen-Remote client and DialUpVPN User, and make sure the two match *Peer gateway addressmisconfiguredwhen configuring the IKE Gateway.Resolution:Correct the gateway address on the remote side*Peer IDmisconfigured.The ifremote end has a dynamic IP address, then the peer ID ismisconfigured. Basically, the peer id that was received in the phase 1 negotiation does not match the peer id in theikeconfiguration.Resolution:Modify the peer id on the local device and the local id on the remote device so they are the same*Wrong outgoing interface defined in the IKE Phase 1 gateway.Resolution: Modify the outgoing interface in phase 1 so it matches the interface that the IKE negotiation will be going out of.



Leave a Reply 1

Your email address will not be published. Required fields are marked *


seenagape

seenagape

I have the same idea. D