Which is the best command to verify that you have a route to host 1.1.1.5 available on your NetScreen device?
A.
ping
B.
get route
C.
traceoute
D.
get interface
E.
get route ip 1.1.1.5
Explanation:
Description: Use the route commands to display entries in the static route table.
The get route command displays:
The IP address, netmask, interface, gateway, protocol, preference, metric, and owner vsys
The protocol value can be any of the following:
– C (Connected)
– S (Static)
– A (Auto Exported)
– I (Imported; that is, route imported from another virtual router)
– iB (internal BGP)
– eB (external BGP)
– O (OSPF)
– E1 (OSPF external type 1)
– E2 (OSPF external type 2)
Use the get route command to see if the NetScreen device has a route to the IP address on the correct interface.
Syntax:
get route [id id_num | ip [ ip_addr ] | prefix ip_addr/mask | protocol { bgp | connected | imported | ospf | rip | static } | summary]