Click the Exhibit button.
[edit protocols ospf area 0.0.0.0]
user@host# run show security ike security-associations
Index State Initiator cookie Responder cookie Mode Remote
Address
3289542 UP 48d928408940de28 e418fc7702fe483b Main
172.31.50.1
3289543 UP eb45940484082b14 428086b100427326 Main 10.10.50.1
[edit protocols ospf area 0.0.0.0]
user@host# run show security ipsec; security-associations
Total active tunnels: 2
ID Algorithm SPI Life:sec/kb Mon lsys Port Gateway
<131073 ESP:des/ shal 6d40899b 1360/ unlim – root 500 10.10.50.1
>131073 ESP:des/ shal 5a89400e 1360/ unlim – root 500 10.10.50.1
<131074 ESP:des/ shal c04046f 1359/ unlim – root 500 172.31.50.1
>131074 ESP:des/ shal 5508946c 1359/ unlim – root 500 172.31.50.1
[edit protocols ospf area 0.0.0.0]
user@host# run show ospf neighbor
Address Interface State ID Pri Dead
10.40.60.1 st0.0 Init 10.30.50.1 128 35
10.40.60.2 st0.0 Full 10.30.50.1 128 31
[edit protocols ospf area 0.0.0.0]
user@host# show
interface st0.0;
You have already configured a hub-and-spoke VPN with one hub device and two spoke devices. However, the
hub device has one neighbor in the Init state and one neighbor in the Full state.What would you do to resolve this problem?
A.
Configure the st0.0 interface under OSPF as a nonbroadcast multiple access interface.
B.
Configure the st0.0 interface under OSPF as a point-to-multipoint interface.
C.
Configure the st0.0 interface under OSPF as a point-to-point interface.
D.
Configure the st0.0 interface under OSPF as an unnumbered interface.