which statement correctly describes the cause of this problem?

Refer to the Exhibit.

You are troubleshooting an interface where there are reports that ge-2/1/0 is not able to use more
than 50% of its full bandwidth.
According to the output shown in the exhibit, which statement correctly describes the cause of this
problem?

Refer to the Exhibit.

You are troubleshooting an interface where there are reports that ge-2/1/0 is not able to use more
than 50% of its full bandwidth.
According to the output shown in the exhibit, which statement correctly describes the cause of this
problem?

A.
The exp-default classifier is in use on the interface.

B.
The input queues are using the default scheduler.

C.
There is a 500 Mbps shaping rate configured.

D.
The interface supports eight queues but is only using four queues.

Explanation:



Leave a Reply 0

Your email address will not be published. Required fields are marked *