What is the problem?

In preparation for future expansion, a user decides to configure a stand-alone SRX Series
device for chassis-clustering mode. The user enters the command set chassis cluster
cluster-id 0 node 0 reboot on the device. After the device reboots, the user sees this output:
user@host> show chassis cluster status error: Chassis cluster is not enabled. user@host>
The device does not enter chassis-clustering mode. What is the problem?

In preparation for future expansion, a user decides to configure a stand-alone SRX Series
device for chassis-clustering mode. The user enters the command set chassis cluster
cluster-id 0 node 0 reboot on the device. After the device reboots, the user sees this output:
user@host> show chassis cluster status error: Chassis cluster is not enabled. user@host>
The device does not enter chassis-clustering mode. What is the problem?

A.
Node ID 0 is not valid for a chassis cluster.

B.
An SRX Series device will not enter chassis-clustering mode unless the fxp0 and fxp1
interfaces are defined in the configuration.

C.
An SRX Series device will only enter chassis-clustering mode when it finds a peer that is
also configured for chassis-clustering mode.

D.
Cluster ID 0 is not valid for a chassis cluster.



Leave a Reply 0

Your email address will not be published. Required fields are marked *