What is the default block size for LUNs, and where is it changed?
A.
4k, Under Project Properties -> General tab -> Default Settings section
B.
4k, Under Share Properties -> General tab -> Default Settings section
C.
8k, Under Project Properties -> General tab -> Default Settings section
D.
8k, Under Share Properties -> General tab -> Default Settings section
Explanation:
*Volume block size
The native block size for LUNs. This can be any power of 2 from 512 bytes to 128K, and the
default is 8K.
*General Project Properties
This section of the BUI controls overall settings for the project that are independent of any
particular protocol and are not related to access control or snapshots. While the CLI groups all
properties in a single list, this section describes the behavior of the properties in both contexts.
The following section is included:
LUN Creation Defaults
These settings are used to fill in the default values when creating a LUN. Changing them has no
effect on existing LUNs. More information can be found in the appropriate shares section.
Volume size
Thin provisioned
Volume block size