You are troubleshooting interface net3 and you enter the following sequence of commands:
Your next command should be:
A.
ipadm up-addr net3/v4
B.
ipadm enable-if -T net3
C.
<ipadm create-vnic -a 192.168.1.25/24 net3/v4
D.
ipadm create-ip -T static -a 192.168.1.25/24 -n net3
E.
ipadm create-addr -T static -a 192.168.1.25/24 net3
Explanation:
If you are assigning a static IP address, use the following syntax:
# ipadm create-addr -T static -a address addrobj
where addrobj uses the naming format interface/user-defined-string, such as e1000g0/v4globalz.
Note:
create-addr [-t] -T static [-d] -a {local | remote}=addr[/prefixlen], … addrobj
Creates a static IPv4 or IPv6 address on the interface specified in addrobj. If the interface on which the address
is created is not plumbed, this subcommand will implicitly plumb the interface. The created static address will
be identified by addrobj.
By default, a configured address will be marked up, so that it can be used as a source or destination of or for
outbound and inbound packets.