On server A, you enter the following command to add a static route to serverA route -p add -host 192.168.1.101
192.168.1.101 -static
What is the purpose of this command?
A.
to temporarily bypass IP Filter rules
B.
to specify an IPMP target IP address to in.mpathd
C.
to specify routing to an adjacent network when in.rdisc is not used
D.
to specify routing to an adjacent network when in.routed is not used
E.
to ensure the IP address for serverB is not flushed from the ARP cache
F.
to optimize link aggregation using a direct connection between two systems
Explanation:
Note: # route -p add -host destination-IP gateway-IP -static
where destination-IP and gateway-IP are IPv4 addresses of the host to be used as a target.
For example, you would type the following to specify the target system 192.168.10.137, which is on the same
subnet as the interfaces in IPMP group itops0:
$ route -p add -host 192.168.10.137 192.168.10.137 -static
This new route will be automatically configured every time the system is restarted. If you want to define only a
temporary route to a target system for probe-based failure detection, then do not use the -p option.