which two combinations of devices should be used to cre…

Refer to the Exhibit.

Refer to the Exhibit. The list of devices attached to vmhba1 will be the basis for configuring a VMware Virtual SAN using Manual Mode.
Based on the exhibit, which two combinations of devices should be used to create Disk Group(s)? (Choose two.)

Refer to the Exhibit.

Refer to the Exhibit. The list of devices attached to vmhba1 will be the basis for configuring a VMware Virtual SAN using Manual Mode.
Based on the exhibit, which two combinations of devices should be used to create Disk Group(s)? (Choose two.)

A.
One Disk Group with one Flash Drive and three HDDs

B.
Two Disk Groups with one Flash Drive and two HDDs each

C.
One Disk Group with one Flash Drive and four HDDs

D.
Two Disk Groups with two Flash Drives and four HDDs each



Leave a Reply 9

Your email address will not be published. Required fields are marked *


Chris Ciavola

Chris Ciavola

The 2V0-621 (VCP6-DCV) exam has been updated to 2V0-622 (VCP6.5-DCV) exam now! New 2V0-622 Exam Questions and Answers Updated Recently (19/June/2017):

NEW QUESTION 51
Which two features are deprecated in Network I/O Control 3 (NIOC3)? (Choose two.)

A. Class Of Service (COS) Tagging
B. Bandwidth Allocation
C. User-defined network resource pools
D. Admission control

Answer: AC

NEW QUESTION 52
An administrator runs the command esxcli storage core device list and sees the following output:
……
What can be determined by this output?

A. The device is a being used for vFlash Read Cache.
B. The device is in a Permanent Device Loss (PDL) state.
C. The device is a local Solid State Device (SSD).
D. The device is in an All Paths Down (APD) state.

Answer: B

NEW QUESTION 53
What are two use cases for Fibre Channel Zoning in a vSphere environment? (Choose two.)

A. Increases the number of targets presented to an ESXi host.
B. Controls and isolates paths in a fabric.
C. Controls and isolates paths to an NFS share.
D. Can be used to separate different environments.

Answer: BD

NEW QUESTION 54
Which two considerations should an administrator keep in mind when booting from Software Fiber Channel over Ethernet (FCoE)? (Choose two.)

A. Software FCoE boot configuration can be changed from within ESXi.
B. Software FCoE boot firmware cannot export information in FBFT format.
C. Multipathing is not supported at pre-boot.
D. Boot LUN cannot be shared with other hosts even on shared storage.

Answer: CD

NEW QUESTION 55
An administrator notices that there is an all paths down (APD) event occurring for the software FCoE storage. What is a likely cause?

A. Spanning Tree Protocol is enabled on the network ports.
B. Spanning Tree Protocol is disabled on the network ports.
C. Spanning Tree Protocol is enabled on the storage processors.
D. Spanning Tree Protocol is disabled on the storage processors.

Answer: A

NEW QUESTION 56
Which two statements are true regarding iSCSI adapters? (Choose two.)

A. Software iSCSI adapters require vmkernel networking.
B. Independent Hardware iSCSI adapters offload processing from the ESXi host.
C. Dependent Hardware iSCSI adapters do not require vmkernel networking.
D. Independent Hardware iSCSI adapters require vmkernel networking.

Answer: AB

NEW QUESTION 57
An administrator is configuring virtual machines to use Worldwide Port Names (WWPNs) to access the storage. Which two conditions are required? (Choose two.)

A. The switches in the fabric must be N-Port ID Virtualization aware.
B. The virtual machines must be using passthrough Raw Disk Mapping (RDMp).
C. The virtual machines must be using Virtual Machine Disk (VMDK).
D. The switches in the fabric must be Storage I/O Control aware.

Answer: AB

NEW QUESTION 58
Which two statements are true regarding VMFS3 volumes in ESXi 6.x? (Choose two.)

A. Creation of VMFS3 volumes is unsupported.
B. Upgrading VMFS3 volumes to VMFS5 is supported.
C. Existing VMFS3 volumes are unsupported.
D. Upgrading VMFS3 volumes to VMFS5 is unsupported.

Answer: AB

NEW QUESTION 59
Which three statements are correct regarding Fibre Channel over Ethernet (FCOE)? (Choose three.)

A. The network switch must have Priority-based Flow Control (PFC) set to AUTO.
B. The network switch must have Priority-based Flow Control (PFC) set to ON.
C. Each port on the FCoE card must reside on the same vSwitch.
D. Each port on the FCoE card must reside on a separate vSwitch.
E. The ESXi host will require a reboot after moving an FCoE card to a different vSwitch.

Answer: ADE

NEW QUESTION 60
Which two statements are true regarding Virtual SAN Fault Domains? (Choose two.)

A. They enable Virtual SAN to tolerate the failure of an entire physical rack.
B. Virtual SAN ensures that no two replicas are provisioned on the same domain.
C. Virtual SAN ensures that all replicas are provisioned on the same domain.
D. They require VMware High Availability (HA) to ensure component distribution across domains.

Answer: AB

NEW QUESTION 61
An administrator created a six node Virtual SAN cluster, created a fault domain, and moved three of the six nodes into that domain. A node that is a member of the fault domain fails. What is the expected result?

A. The remaining two fault domain members are treated as failed.
B. The remaining two fault domain members stay protected by the domain.
C. One of the non-member nodes will be automatically added to the fault domain.
D. VMware High Availability will restart virtual machines on remaining nodes in the domain.

Answer: A

NEW QUESTION 62
Where is a Virtual SAN Fault Domain configured?

A. VMware Virtual SAN Cluster configuration
B. VMware High Availability Cluster configuration
C. Distributed Resource Scheduler configuration
D. Datacenter Advanced Settings configuration

Answer: A

NEW QUESTION 63
Which statement is true for the Path Selection Plug-In VMW_PSP_MRU?

A. VMW_PSP_MRU is default for a majority of active-active and active-passive arrays.
B. VMW_PSP_MRU will remain on the selected path even if the state were to change.
C. VMW_PSP_MRU is recommended for Virtual SAN.
D. VMW_PSP_MRU will have no preferred path setting for the Plug-In.

Answer: D

NEW QUESTION 64
Which two tasks does the Pluggable Storage Architecture (PSA) perform? (Choose two.)

A. Handles I/O queueing to the logical devices.
B. Handles physical path discovery, but is not involved in the removal.
C. Handles physical path discovery and removal.
D. Handles I/O queueing to FC storage HBAs.

Answer: AC

NEW QUESTION 65
Which two statements are true regarding Storage Multipathing Plug-Ins? (Choose two.)

A. The default Path Selection Policy is VMW_PSP_MRU for iSCSI or FC devices.
B. The default Path Selection Policy is VMW_PSP_FIXED for iSCSI or FC devices.
C. VMW_PSP_MRU is typically selected for ALUA arrays by default.
D. VMW_PSP_FIXED is typically selected for ALUA arrays by default.

Answer: BC

NEW QUESTION 66
What is the command to list multipathing modules on an ESXi 6.x host?

A. esxcli storage core list plugin –plugin-class=MP
B. esxcli storage core list plugin –class-plugin=MP
C. esxcli storage core plugin list –plugin-class=MP
D. esxcli storage core plugin list –class-plugin=MP

Answer: C

NEW QUESTION 67
……

P.S. These New 2V0-622 Exam Questions Were Just Updated From The Real 2V0-622 Exam, You Can Get The Newest 2V0-622 Dumps In PDF And VCE From — http://www.passleader.com/2v0-622.html (305q VCE and PDF)

Good Luck!

Keith Serenil

Keith Serenil

New VCP6.5-DCV 2V0-622 Exam Questions and Answers Updated Recently (19/July/2017):

NEW QUESTION 326
In which scenario will vSphere DRS balance resources when set to Fully Automated?

A. Hosts with only shared storage
B. Hosts are part of a vSphere HA cluster
C. Power Management is set to Balanced on hosts
D. Hosts with shared or non-shared storage

Answer: A

NEW QUESTION 327
Which two configurable options are available in Boot Options for a virtual machine? (Choose two.)

A. Tools Upgrades
B. Encryption
C. Firmware
D. Force BIOS setup

Answer: CD

NEW QUESTION 328
What VMware technology can be used to move physical servers to the vSphere infrastructure?

A. VMware vMotion
B. VMware Converter
C. VMware vCenter Server
D. OVF transport

Answer: B

NEW QUESTION 329
Upgrading vCenter Server with Microsoft SQL database fails with the following error message:
“The DB User entered does not have the required permissions needed to install and configure vCenter Server with the selected DB. Please correct the following error(s): %s”
What could cause this error?

A. incorrect ports open on SQL Server
B. incorrect database on the SQL server
C. incorrect compatibility mode on the SQL server
D. incorrect permission on SQL Server database

Answer: C

NEW QUESTION 330
What is a potential downside of having more than four paths per datastore?

A. limits the storage protocols
B. increases storage latency for VM
C. limits the path selection policies
D. limits the number of LUNs per host

Answer: D

NEW QUESTION 331
Which feature facilitates the sharing of templates via vCenter Server?

A. Content Library
B. OVF
C. folders
D. vApp

Answer: A

NEW QUESTION 332
A vSphere Administrator is in the process of configuring replication for a virtual machine, but is not able to select the Recovery Point Objective (RPO) value of 5 minutes.
……
Which statement could explain why the RPO value cannot be lower than 15 minutes?

A. The OS quiescing option is selected for Replication options.
B. The virtual machine hardware version is not compatible.
C. The target and source sites use different types of datastores.
D. The target and source sites are not using VMFS 6.0 datastore.

Answer: A

NEW QUESTION 333
What advanced parameter defines a custom isolation IP address for a vSphere HA cluster?

A. das.usedefaultisolationaddress
B. das.isolationshutdowntimeout
C. fdm.isolationpolicydelaysec
D. das.isolationaddress

Answer: D

NEW QUESTION 334
Which three VMware-recommended best practices should an administrator follow before upgrading to vSphere 6.5? (Choose three.)

A. Disconnect ESXi host from vCenter.
B. VMware Tools are installed in the virtual machine.
C. Ensure that the system hardware complies with ESXi requirements.
D. Back up the host.
E. Check the interoperability of any other software integrated with vSphere.

Answer: CDE

NEW QUESTION 335
What are two requirements to enable EVC in vSphere DRS cluster? (Choose two.)

A. CPUs must be from the same vendor.
B. EVC must use the lowest possible baseline supported by the hardware.
C. CPUs must be in the same family and of the same speed.
D. No VMs may be running in the cluster.

Answer: AD

NEW QUESTION 336
Which method is supported for backing up the virtual machine that contains vCenter Server?

A. differential
B. incremental
C. full image
D. individual disks

Answer: C

NEW QUESTION 337
……

P.S. These New 2V0-622 Exam Questions Were Just Updated From The Real 2V0-622 Exam, You Can Get The Newest 2V0-622 Dumps In PDF And VCE From — https://www.passleader.com/2v0-622.html (375q VCE and PDF)

Good Luck!