A vSphere Standard Switch has been configured for IP-based load balancing using two uplinks.
A new uplink is added to the vSwitch.
What is the status of the uplink by default?
A.
The uplink is placed in standby mode until it is added to the active NIC team.
B.
The uplink is marked as active but does not participate in the active NIC team until assigned to
a port group.
C.
The uplink is marked as active, but cannot be used by the active NIC team until it is added to
the existing 802.3ad group on the physical switch.
D.
The uplink is marked as unused until it is added to the active NIC team.
Explanation:
The new uplink will be marked as active but it cannot use active NIC team until it is added to an
existing 802.3ad group on the physical switch.
http://h20000.www2.hp.com/bc/docs/support/SupportManual/c01990371/c01990371.pd
f(page 26 onwards)