Refer to the exhibit.
Host 1 is assigned the static IP address 10.1.1.200 as shown.but host 2 and host 3 have
dynamic IP address .DHCP snooping and dynamic ARP inspection are configure on the
network.What command or command sequence must you configure on the
network.What command or command sequence must you configure on the switch to
allow Host 1 to communicate with the other hosts?
A.
Switch(config)#ip source binding 001c.0f12.abcd vlan 100 10.1.1.200 interface
f0/10
B.
Switch(config)#interface f0/10 Switch(config-if)#ip dhcp snooping trust
C.
Switch(config)#no arp inspection enable
D.
Switch(config)#ip dhcp relay information option
E.
Switch(config)#arp 10.1.1.200 001c.0f12.abcd arpa
F.
Switch(config)# interface f0/10 Switch(config-if)#switchport access vlan 100
Switch(config-if)#switchport mode host